On some projects, when I select Finish, the window is blank/solid grey and the program becomes unresponsive. After a minute or so, the program starts responding again. If I minimize and then restore ABB, the Finish page displays properly. Any ideas what might be causing this?
While building, ABB 1.1 begins by "writing part files", then proceeds to "joining part files". Using the same project file, ABB 1.0.11 goes straight to "joining part files", and does not "write part files". Import cd and build settings are identical (64 Kbps, Mono, 44.1 kHz, pass through).
Is there a setting somewhere that I'm missing. I thought ABB only needed to "write part files" if the quality of the source files was different than the desired build quality. In ABB 1.1 does this mean the files are being re-encoded while the project builds?
Thanks!
System info: ABB 1.1, OSX 10.5.7, QT 7.6 (1290), iTunes 8.1.1 (10), iPod Touch 2G with 2.2.1 firmware
|